Walker Workshop Parts List:
Per/Person

	2 - GMW  adapter -  w/ #2 screw and washer
	1 - GM2
	1 - GM3

	4 - 74AC240

	2 - 6.8uF caps, - tactile RC
	6 - 0.01uF mono-caps, -  motor noise filter
	4 - 0.22uF mono-caps, - bicore
	4 - 22uF caps,  - bypass caps

	2 - 1M5 resistors, - tactile RC
	2 - 1 Meg resistors, - bicore timing
	2 - 3M3 resistors, - bicore timing
	1 - 2M2 resitor, - bicore timing
	7 - 47K resistors, -  enables and IMX

	6 - 2K2 resistors,  1/8watt,  - current limit-LEDs, Nu,BC2

	2 - 4K7 resistors,  -  in-line tactile damper
	2 - 100 Ohm  resistors, - 25cChg
	2 - 1N914 diodes,  - IMX
	7 - LEDs,  ( 4 - red, 2 - green, 1 - yellow )

	1 - SWT1 ( or similar to fit that spacing)
	2 - AA  Battery Holders
	32 - Machine Pins

	8 - #2, 1/4" machine screws - for leg mounts and  tactile sensors
	4 -  #4,  1 1/4" counter sunk,  motor mounts
	2 -  #4,  5/8"   counter-sunk, body
	4 -  #4,  1/4" counter sunk, battery holders
	4 -  #4,  3/4" round-head,  circuit board mounts
	2 - #4,   5/8" round-head,  tactile sensor mount

	1 - Gumby Wire - Legs,  #10 gauge solid copper wire, 2 meters ( front 44", rear 34")

	1 - Top Plate - milled spruce, for mounting Tactile Sensors, Circuit Board.
	1 - Body -  milled spruce, for mounting Top Plate, Battery Holders and Motors.

	2 - 7/32" diameter,  Brass Tubes,  3/4" length - Tactile Sensors
	2 - #4 crimp-rings - Tactile Sensors
	 1/2 - tactile spring wire. - Tactile Sensors
	2 - plastic video cable clamps - Tactile Sensors

	4 - #8,  crimp-rings,  - Circuit Board mounting
	4 - #4,  3/8"  Nylon Spacers    -  Circuit Board mounting